Best bracing framing technique for 18-23″ deck on sloped grade

Posted · Add Comment
d9c7a43967.jpeg
0 Flares Twitter 0 Facebook 0 Google+ 0 StumbleUpon 0 LinkedIn 0 Email -- Filament.io 0 Flares ×

by Simon

(Ottawa, ON)

I’m in the planning stages of a 16×18′ free-standing deck. I want to keep the total height below 24″ above grade (ideally 23″ for some extra margin) at its highest point to avoid having to get a building permit & inspections.

My grade drops by approx. 5 inches over the 18′ run from the house to what will eventually be the perimeter of the deck.

What do you suggest would be the best way to brace and frame using the Titan Deck Foot?

My original plan was to notch 6×6 posts for my double 2×10 beams, with 2×8 joists on top of that, but by the time you add up the nominal height of the beam, joists and 5/4 decking, I am already at 17.5″. If the deck can be no higher than 23-24″ above grade at its highest point, the deck near the house would need to be 5″ less, or 18-19 in. to allow for the grading. This would leave me with almost no base for the post once notched. Is there a minimum height/length notched posts must be to properly sit in the base? Some of the example photos on the site show what appear to be very short posts, but I’m guessing there is at least a few inches before notching to allow for it to be connected to the post base.

What are my other options? I know you can lay beams or joists directly in the post brackets, but I’m guessing this would only work on level ground…

Can I do the notched posts and then just hang my joists from the face of the beams? That would seem to solve my problem of the overly short post lengths, but will it result in a secure frame?


Editor’s Comments

This is a great question. And I have uploaded some photos and illustrations of how you can cheat a bit using short 6×6 posts, 2×8 beams and 2×8 joists and with your decking come in below the 24″ mark.

Higher Elevation View

Lower Elevation View

Side view of lower elevation for beam, post and deck foot anchor

Notice how the beam was just set directly into the post bracket. Shims or spacers are required to make the beam fit perfectly with the post bracket. Also This technique requires that each of the footings are level with each other so that the beam is level along its length. If not, you may have to shim to get it level.

You can also use joist hangers from the inside face of the beam. So I will demonstrate that also. Just wanted to post something quickly to let you know you had a great question and I am sure many other people have had the same question.

You can learn more about this by reading this article on the Titan Deck Foot Anchor.

 
 
DMS
0 Flares Twitter 0 Facebook 0 Google+ 0 StumbleUpon 0 LinkedIn 0 Email -- Filament.io 0 Flares ×